The stylus is a special wand of small size that is needed to control the touch screens of tablets or phones. Many will wonder why this is necessary, because there are fingers? But unfortunately, sometimes you have to click small icons. Make it a finger is quite problematic. Therefore, you have to use the stylus, as the speed and accuracy of pressing is much higher.
In this article we will tell you how you can make a stylus for the tablet with your own hands.
What you need for making
Currently there are several types of screens. The stylus will not work on every device.. The fact is that the principle of the screen is different. therefore a little test is needed before manufacture.
What screen is needed
Take your device and swipe the cap on the screen.
If you managed to do this, it means that resistive screen. Its advantage is that You can use any wand or similar item to control it..
If you could not manage to control the screen with a pen cap, this means that capacitive screen. On its surface is a thin conductive layer. Manage such a screen can only be using conductive elements. A person is able to conduct current, so you can interact with the phone with your finger.
What material will fit
For the manufacture of the stylus perfect foil, as it can perfectly conduct electric current.
IMPORTANT! To use only foil, we strongly do not recommend.
Because the foil is still metal, albeit thin. From this, the screen will soon be greatly scratched. We will use foil as the main conductive material. We advise you to take a foil from chocolate, as it is much thicker compared to food foil.
What materials and tools will be needed additionally
To make a safe stylus for a tablet, in addition to foil, we also need the following materials.
- The tube from the handle.
- Double sided tape.
- Cotton swab.
- Glue pencils.
In the process of creation, we will need instruments.
- Scissors.
- Glue gun.
ATTENTION! If the child is engaged in independent production of the stylus, then this should take place under the close supervision of the parents.
The fact is that scissors, and even more so the glue gun are tools of increased danger.
How to make a stylus with your own hands
- Take an unnecessary ballpoint pen and remove all the elements from it, since we only need a pipe.
- Next, cut one end of a cotton swab with scissors and insert it into the empty case of a ballpoint pen. This should be done so that the soft cotton edge is located outside.
- Then plug in the glue gun and wait a couple of minutes. In this case, the glue will have time to soften well.
- After that, pour the glue inside the tube from the handle in order to fix the cotton swab well.
IMPORTANT! Do not leave the glue warm up for more than 5 minutes. Since the glue, having warmed up to a high temperature, can melt the plastic body of the handle.
- Cut a strip of foil along the length of the body of the handle. Apply double-sided tape to the edges of the foil for better fixation. Otherwise, it just slides off the tube.
- Then glue the edge of the foil to the handle tube and begin to tightly wrap the foil. At the same time you need to press one edge tightly to a cotton swab. A shiny foil layer should be placed outside. It has the best conductive properties.
- Moisten a cotton swab with a homemade stylus with a drop of water. Now he is fully ready to manage the tablet. Such a stylus will need to be moistened periodically, as water will evaporate from the cotton during use..
IMPORTANT! When the stylus does not work, it is worth checking the fit of the foil to the wet cotton. If there is no good contact in this place, the capacitive screen will refuse to work with such a stylus.
We hope that our article has helped you understand how you can make a stylus for a tablet. Try to create a stylus by following our instructions, and then you will succeed. We wish you success!
Leave Your Comment