Sliding door repair: replacing rollers and rails

Each owner of the cabinet cannot be insured against the fact that malfunctions in it will appear sooner or later. Therefore, it is necessary to know certain nuances of operating the product, for example, what to do if repair of a sliding wardrobe is required, replacement of rollers and guides. This will be discussed in the article.

What often breaks down in a sliding wardrobe system

Repair of sliding wardrobes, replacement of rollers in it, are most often noted in those people who do not carry out preventive maintenance. First you need to figure out what causes the problems. First of all, these include:

  1. The ingress of various contaminants into the device or the accumulation of dust;
  2. Failure of rollers;
  3. Incorrect location of mechanisms.

In any case, the cabinet design consists of two elements: the main part is the frame, and mechanical. Thus, problems with the first of them appear frequently. Usually this occurs due to long operation, which results in small gaps between the wings.

A problem may also arise due to the sufficiently large load that the structure assumes. In any case, the correction of defects should not be delayed.

How to replace the rollers in the design

A defect with rollers is believed to be the most common. It can be seen with difficulties opening the cabinet door. To fix the problem, you must first determine the type of product.

The upper and lower rollers may fail. To fix the upper need to do the following:

  • Unscrew the screws;
  • Extract the item that is damaged;
  • Install a similar item;
  • Finally, fix the delivered parts.

In case you are going to replace the support rollers, you need to perform other actions. Namely: the removal of the wings (they are not fixed), use the hexagon to unscrew the adjusting bolts, replace the old elements with new ones.

Features of replacing rails

The guides should be changed if you notice that the sash is jammed while in a certain position. This fact indicates damage. To remedy the situation, you need to start by dismantling the cabinet door.

And after removing the wings, it is worth replacing the damaged parts and installing new ones in the right place.

ATTENTION! If you wish to fix the structure, it is recommended that the rail be mounted on new fasteners. And the original can be deleted.

Prevention of problems

To prevent or partially eliminate the occurring defects in the operation of the cabinet, do not forget about some measures. To begin with, it is worthwhile to understand that it is advisable to keep the cabinet always clean, to look after it regularly. This is necessary to get rid of small particles, due to which various kinds of pollution can occur.

Therefore, the first of the tips will be the frequent use of a vacuum cleaner. The second is the application of special grease, since the parts are subject to constant friction, and it is necessary to extend the life of the device. So you provide the cabinet with a smooth sliding mechanisms.

In addition, it is worth watching the appearance of the chipboard, of which the structure consists.

IMPORTANT! It is impossible to place the cabinet next to heating devices or in rooms with high humidity, this can lead to deformation of its surface. It is recommended to wipe the product with soapy water, then dry it thoroughly.

Watch the video: How To Replace The Rollers On An Aluminium Sliding Patio Door (March 2024).

Leave Your Comment